Rounded Cleaning Mat for 3D Printing

The GSW silicone cleaning mat for 3D printing is designed to be the perfect hobby accessory for any resin 3D printer or painter. The flexible silicone mat with raised edges is made of flexible silicone with non-stick properties, so it can be rolled up to fit easily in a hobby toolbox. It has a 3.5mm raised edge all around to prevent spills of resin, cleaning alcohols, and even paints.

This silicone mat with raised edges has been manufactured from soft-touch silicone that will protect your table from paint spills, making it perfect for your hobby room or anywhere else you don't want to make a mess. The non-slip backing provides a firm grip on the table, preventing it from sliding. Easy Clean with water or alcohol, or even in the dishwasher.

This set contains 1 silicone mat.
Color: Green
Size: 410x310mm

WARNING: Do not cut with sharp tools or cutters on this mat as it could cut it irreversibly. This is not a cutting mat.

How do you clean resin after 3D printing?

Being able to clean your resin 3D prints after printing is an important step in the post-processing workflow to ensure the best possible quality of the final product. Here is a general guide on how to clean them after 3D printing:

1. Safety First and foremost: Make sure you are wearing the appropriate safety equipment before handling them. This includes nitrile gloves to protect your skin, safety glasses to protect your eyes, and working in a well-ventilated area.

2. Remove the print: Carefully remove the printed object from the build platform. You can use a plastic spatula to separate it without damaging anything.

3. Drain off the excess: Hold the printed piece over the vat and let the excess drain back into the vat. You can use a soft brush or spatula to help remove the excess.

4. Rinse the print: Once you have removed as much excess as possible, the next step is to clean the print in a bath of isopropyl alcohol or a similar solvent. This helps dissolve any remaining uncured resin. In this step, it is very helpful to have a silicone cleaning mat to protect your work surface and contain the liquids.

5. Drying: After cleaning, it is necessary to dry it completely. Use compressed air, paper towels, or a soft cloth to remove any remaining alcohol. You can also let it air dry, but this may take longer.

6. Post-curing: After the resin miniatures or bits are completely dry, they need to be post-cured. This is done by exposing them to UV light, which hardens them completely. This can be done using a UV curing cabinet or by leaving them in natural sunlight.

7. Final cleaning: Once cured, you can remove any support structures and sand or polish as needed. It is highly recommended to remove the support structures during the alcohol rinse phase, as they are usually weaker at this stage due to the alcohol and are much easier to remove.

This is a general guide, and the steps may vary depending on the type of resin and printer you are using. is being used.

Not what you're looking for? Check out our paint mats.