Decal Paper - Clear Laser

Create your own custom decals using your printer with our decal paper. Decals should be applied with water; no solvent is required. You can also use a little GSW Decal Softener and GSW Decal Fixative to enhance and protect the finish on uneven or rough surfaces.

Sheets: 5 decal sheets per set
Size: 210 x 270mm (A4)

Use a computer to create your designs or artwork. Because photocopiers and printers cannot print in white, they will always rely on the color of the paper itself to provide the white component your lettering or designs may have. To make a decal with this color, you will need to use white decal paper, or paint or lighten the area where you want to place the decal.

PREPARATION INSTRUCTIONS THE DECAL

Choose the appropriate paper type depending on your printer type, inkjet or laser. Remove any protective film that may be present on the packaging and print your design directly onto the glossy side of the decal paper. For inkjet printing, we recommend using the "photo paper" setting if your printer software allows this option. For laser printing, we recommend using the "transparency paper" setting if your printer software supports this option. In all cases, you should immediately apply a few thin coats of gloss or matte spray varnish to seal the printed image onto the decal paper. This will prevent the ink from smudging, washing off, or cracking during application.

DECAL APPLICATION INSTRUCTIONS
1. Cut out the decal as close as possible to the outer edge of the image. For best results, we recommend using a new blade.
2. Pick up the decal with tweezers and let it soak in water for about 20 seconds. Using warm water can help with this process.
3. Apply the decal to your model using a brush to gently push it off the transfer paper and place it on your model. That's all, folks!

APPLICATION TIPS

• Before applying it to your model, once the decal has soaked long enough, apply a little GSW Decal Fixer to the surface where you plan to place the decal. GSW Decal Fixer will prime the area, leaving a smooth finish that will help prevent and disguise the decal's outline, as well as protect the painted area underneath. If you find it difficult to move the decal around on your model to get the exact placement, you can add a little more GSW Decal Fixer or just water, which will help the decal float on the surface until it can be properly positioned.
• If the surface where you want to apply the decal is flat and Curved surfaces, such as a shoulder pad, can cause wrinkles to form in the decal. To prevent this, once the decal is in place, apply GSW Decal Softener. Let the decal softener work, removing the wrinkles and conforming the decal to the surface underneath. Repeat this step 2-3 times until the wrinkles are completely gone. Remove any excess liquid using a cotton swab. Roll the swab over the decal to prevent it from lifting or shifting. Alternatively, you can use absorbent paper to press down on the decal with a rolling motion, removing any remaining liquid. When using GSW Decal Softener, you won't need to make any trim cuts in the decal to remove wrinkles. Finally, apply GSW Decal Fixer again to the decal and the model surface you've been working on to unify the surface. Add matte or gloss varnish if you feel it's necessary to remove or add a glossy finish.

NOTICE:

INKJET decal paper can be printed with both laser and inkjet printers. LASERJET decal paper, however, can only be printed with laser printers.