Triple-Hexagon Textured Roller

The textured roller is a perfect tool for adding texture and shape to putties, clays, and modeling pastes. It is made of transparent PMMA plastic, a resistant, non-toxic material with non-stick properties that make it easy to use.

Measurements:

• Length: 14.5 cm (5.5")
• Diameter: 2.5 cm (1")
• Pattern Size: 10x10 mm

INSTRUCTIONS FOR USE:

1. Knead or mix the putty or clay until it has the appropriate consistency according to the manufacturer's instructions.
2. Spread the material onto the surface to be textured, ensuring it is uniform and smooth. To facilitate the process, it is recommended to use a [unclear - possibly a surface roughener or similar tool] beforehand. Smooth roller.
3. If the putty is sticky, lightly dampen the roller or apply a thin layer of modeling petroleum jelly to prevent sticking.
4. Roll over the putty with consistent pressure to achieve a uniform texture.
5. When the material is dry or hardened, remove the excess with appropriate tools.

MATERIAL COMPATIBILITY:

The roller is compatible with various putties and clays.

Polymer clays such as Super Sculpey allow you to work without pre-drying and harden by baking. If you are working on MDF wood bases, these can be baked along with the piece at 150°C for 15 minutes, withstanding the heat although they give off a slight odor.

For epoxy putties, the technique varies. Green stuff is usually sticky, so it is advisable to dampen the roller or apply petroleum jelly to modeling. Talcum powder can also help reduce sticking.

Milliput putty is suitable, but it's best not to over-wet it. If it's too sticky, knead it to improve the texture.

*** Cleaning after use is key to maintaining the quality of the rollers.

CLEANING AND MAINTENANCE:

After use, clean the roller with water. For stubborn residue, use the Scratch brushes.

WARNINGS:

Not suitable for children without adult supervision.

EXAMPLES:

Patent number 002568469