Textured Rollers - PACKx6 v2.0

• 1x Smooth Roller
• 1x Factory Floor Roller
• 1x Celtic Roller
• 1x Runic Roller
• 1x Wooden Plank Roller
• 1x Frozen Roller

INSTRUCTIONS:

1. Mix the sculpting putty/clay thoroughly until ready to use, according to the manufacturer's recommendations.

2. Spread the putty/clay onto the surface to be textured. For best results, level and smooth the surface properly before applying the rollers.

*** It is recommended to use a smooth roller for this purpose.

3. Depending on the type of material being used, it may be advisable to dampen the roller to prevent sticking.

4. Roll slowly, applying the same pressure at all points to obtain a consistent texture.

5. Trim off any excess putty/clay. It is recommended to do this once the putty/clay has dried.

MATERIALS:

There are countless putties and clays on the market, and all of them can be textured by applying the appropriate technique.

Generally, polymer clays (like Super Sculpey Beige) are quite easy to work with using these rollers and allow for easy correction of mistakes since they don't dry until baked. If the goal is to create textured bases, we recommend using MDF wood bases, as it's possible to texture the clay directly onto the MDF base and then put everything in the oven, base included. The baking time for clays is 15 minutes at 150ºC. The MDF wood will leave a smell similar to toast, but it won't burn.

In the case of epoxy putties, there are more differences and more techniques to achieve similar results. The good thing is that they don't need to be baked and can be applied directly onto plastic materials.

In the case of greenstuff, which is especially sticky, it will be necessary to wet the rollers with a little water. You can also reduce the stickiness of this putty by applying talcum powder, or for best results, a little modeling petroleum jelly (LINK).

Other epoxy putties such as Milliput putty are also suitable, but we recommend not over-wetting them as this makes them difficult to work with. On the other hand, if the mixture is too sticky, it is best to continue kneading until its stickiness is reduced.

*** With this type of putty, it is very important to clean the rollers properly after use.

CLEANING AND MAINTENANCE:

After finishing working with the rollers, if any material remains on the design, clean with the Scratch Brushes (LINK) with plenty of water.

SAFETY:

These Rollers are tools that should not be used by minors without adult supervision.